Table of Contents
Advertisement
explicitly designed for LVDS. Very often all GND wires are put together in the connector.
These kinds of cables must not be used for LVDS.
80MB/sec. or 160MB/sec synchronous data transfer rates
Up to 12 Meters cable length
It is very important for you to observe the information and notes given in this section of the
User's Manual because it helps to ensure that the SCSI devices that are used in connection
with the ICP Controllers are operated in a successful, long-lasting and trouble-free manner.
In many cases, this information is not only applicable to ICP Controllers, but in general to
all those SCSI systems which, like the ICP Controllers, use Wide/Ultra2 or Ultra 160 tech-
nology. According to its definition, the SCSI bus provides access to several participants that
are physically connected through an appropriate SCSI bus cable. To achieve a sufficiently
good signal quality, it is not only recommended to use very good cables and connectors,
but also to terminate both ends of the cable properly. For an unambiguous identification
on the bus, all participants have a unique number – the so-called SCSI-ID. Further details
on these topics can be found on the following pages.
Please note that 98% of all SCSI-related problems are caused by bad SCSI cables,
wrong SCSI bus termination and duplicate SCSI-IDs.
B.4.1 SCSI Cables
The quality and overall length of the cable, as well as the number and quality of the SCSI
connectors is very important for both internal and external SCSI cables. Generally, internal
SCSI cables are 50 or 68 conductor flat ribbon cables. To connect external SCSI devices,
round and shielded cables with appropriate connectors are typically used. External round
cables should have a SCSI-compliant placement of the inside conductors and should be
approved for LVDS operation. Besides the cables, the right connectors for a cable are also
very important. It is highly recommend to use highest quality connectors, only.
The following table shows the maximum cable lengths allowed for a given transfer rate.
Based on many years of SCSI experience, the lengths we recommend are in some cases
shorter than theoretically possible. The information in the table refers to one SCSI channel
and represent the overall length of the cable, including internal and external parts.
SCSI Bus
SCSI Mode
Width
8 Bit, narrow
Fast
8 Bit, narrow
Fast-20, Ultra
8 Bit, narrow
Fast-40, Ultra2
16 Bit, wide
Fast
16 Bit, wide
Fast-20, Ultra
16 Bit, wide
Fast-40, Ultra2
16 Bit, wide
Fast-80, Ultra160
In addition to specifications mentioned above, the following should be kept in mind when
selecting and installing SCSI cables:
Always install SCSI cables that are as short as possible. The lengths in the table above
are absolute maximum lengths. (Total length of internal and external cables per chan-
nel).
38
Bus-
Synchronous
Type
Data Transfer
Rate
SE
10 MB/sec.
SE
20 MB/sec.
LVDS
40 MB/sec.
SE
20 MB/sec.
SE
40 MB/sec.
LVDS
80 MB/sec.
LVDS
160 MB/sec.
Number of
Max. Cable
devices
Length
7
2.0 meters
4
1.5 meters
7
12 meters
15
2.0 meters
4
1.5 meters
15
12 meters
15
12 meters
Advertisement
Table of Contents
