Table of Contents
Advertisement
CONNECTING YOUR TV
Using the controls
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
ORANGE LED - Programme timer set (digital only)
RED LED – Programme timer Active (digital only)
Switching on
If the RED LED is unlit check that the mains plug is connected
to the power supply. If the picture does not appear press
the remote control, it may take a few moments. The GREEN
LED will be lit.
To put the television into Standby press
control. To view the television press
take a few seconds to appear.
Using the remote control
Press M on the remote control to see the menus.
The menu appears as a list of five topics. As each symbol is
I
i
selected by pressing
or
on the navigation ring on the
remote control, its respective options will appear below.
NOTE: The same menu is displayed in DTV (Digital TV) and
ATV (Analogue TV) modes; however some items are greyed out
in each case.
1
on
1
on the remote
1
again. The picture may
10
RED LED – Standby
GREEN LED – Power on
U
To use the options, press
move up and down through them and Q,
required choice. Follow the on-screen instructions. The
functions of each menu are described in detail throughout the
manual.
Using the controls
To alter the volume press –
To alter the programme position press
I
i
U
u
Press MENU and
,
,
or
options.
Press MENU to finish.
To select an external input, press
input source is selected as described on page 32.
Please always refer to the owner's manual of the equipment to
be connected for full details.
Please note: Inserting the headphone plug will mute the sound
from all speakers.
COMMON INTERFACE
The Common Interface
is for a Conditional
Access Module (CAM).
Contact a service
provider.
Headphone jack
Standby
u
and
on the remote control to
I
i
or
to select the
2
+.
b p B
.
to control the sound and picture
o
until the appropriate
Advertisement
Table of Contents
