A wide variety of external equipment can be connected via the sockets located on the side and back of the
TV. Whilst all the necessary adjustments and controls for the TV are made using the remote control, the
buttons on the Back of the TV may be used for some
Switching on
If the standby LED is unlit, check that the mains plug is con-
nected to the power and press
side of the television or
switch the television on.
To put the television into Standby, press
remote control or
button
press
again. The picture may take a few seconds to appear.
Note: The active Standby LED colour will turn to red in a few
moments when the TV is switched into Standby.
For energy saving:
Turning the TV off at its mains supply, or un-plugging it, will
cut energy use to nearly zero for all TV's. This is recom-
mended when the TV is not being used for a long time, e.g.
when on holiday.
Reducing the brightness of the screen will reduce energy
Note: Putting the TV into standby mode, will reduce energy
consumption, but will still draw some power.
Controlling the TV
the
button on the back
button on the remote control to
button on the
on the TV. To view the television,
English - 15 -
Using the Remote Control
Press the MENU button on the remote control to see the
menus.
The main menu appears as a group of icons each for a menu
option. Press the Left or Right button to select a topic.
In sub menu screen mode the menu appears as a list. Press
the Up or Down button to select a topic.
To use the options press the Up and Down buttons on the
remote control to move up and down through them and OK,
Left or Right buttons to select the required choice. Follow
the on screen instructions. The functions of each menu are
described in detail throughout the manual.
Using the Controls on the TV
Using the control buttons on the Back of the TV:
• To alter the volume
use.
• To alter the programme position press
on the Back of the TV.
•
Press
and
use
change value.
To select an external input,
priate input source is selected.
Please always refer to the owner's manual of the equipment
to be connected for full details.
functions.
press
or
buttons at the same to view main menu
buttons to navigate
and
press
button until the appro-
.
buttons
to