Toshiba 32AV563 Owner's Manual page 36

Q
Why is the soundtrack in English when a different
audio language has been selected?
A
The programme is currently being broadcast with an
English soundtrack only.
Q
Why is there incorrect or no sound when in DTV
mode?
A
Press s to ensure the hard of hearing option has
not been selected.
Q
What can be done if the PIN number has been
forgotten?
A
Use the Master PIN code of 1276, then change to a
number of your choice. Ensure that no-one else can
use the Master PIN by removing the Owner's Manual.
Q
Why when digital subtitles have been selected are
they not showing on screen?
A
Subtitles are not currently being transmitted by the
broadcaster.
Q
Why are there problems with analogue text?
A
Good performance of text depends on a good strong
broadcast signal. This normally requires a roof or loft
aerial. If the text is unreadable or garbled, check the
aerial. Go to the main index page of the text service
and look for the User Guide. This will explain the basic
operation of text in some detail. If further information
is needed on how to use text see the text section.
Q
Why are there no analogue text sub-pages?
A
There are none broadcast or they have not yet loaded.
l
Press the button to access.
(See text section).
Q
Why is a page number visible at the top of the screen
but no text?
A
Text has been selected but Teletext information is
currently unavailable on the current source.
Q
Why are the LEDs on the front of the television
flashing?
A
Check the table below.
LED indication
LED-2 LED-1
OFF Green (Solid)
OFF Red (Solid)
Orange Red (Solid)
(Solid)
Red Green (Solid)
(Solid)
OFF RED Blinks
0.5 sec cycle
OFF Red Blinks
1 sec cycle
Q
Why are the colours wrong when an NTSC source is
played?
A
Connect the source via a SCART lead and play.
Select Manual Settings from the SETUP menu.
Manual Settings
Colour System: Auto
EXT2
a
Set the Colour to Auto and exit.
b
Go to the Picture Settings menu and adjust the tint.
Q
Why don't the devices connected via HDMI operate
properly?
A
Make sure to use cables with the HDMI logo
(see page 8).
Some early HDMI equipment may not work properly
with the latest HDMI TV products, due to new standard
adoption. Try setting Lip Sync to Off.
37
PROBLEM SOLVING
Condition Solution
The TV is operating
properly.
Standby with Power-
On
Programme timer set
(Digital mode)
Programme timer
Active
(Digital mode)
Power protect Turn OFF the TV and
detection. unplug the power
cord. Plug the power
Abnormal operation
cord in again and turn
of BUS line.
ON the TV.
LED-2 LED-1
A
–
–
–
–