Connecting Loads; Grounding The Generator - Titan TG 4500 Owner's Manual

TITAN
P.O. Box 791
Travelers Rest, S.C. 29690
(800)
MODEL TG 4500
GAS POWERED
ELECTRIC GENERATOR
Model
Voltage
Frequency
Continuous Watts
Surge Watts
DESCRIPTION
MODEL TG 4500 is a gas engine driven, revolving field,
alternating current (AC) generator designed to supply
electrical power for compatible electrical tools, motors,
appliances, and lighting (see wattage reference guide
on page 8 ).
The Model TG 4500 operates at 120 volt and/or 240 volt,
single phase, 60 Hz and will operate devices that require
up to 4000watts continuous, 4500 surge watts.
Figure #1 - Grounding Lug Block
845-4141
TG 4500
120/240
60Hz
4000
4500

CONNECTING LOADS

Add up the Watts of all devices you connect to the TITAN
Generator at one time. Do not exceed 4000 Watts on
TITAN Generator Model TG 4500 (see wattage refer-
ence guide).
The rated Watts of most electrical devices can be found
on its nameplate. The rated Watts of lights can be taken
from the light bulbs. In cases where only Volts and Amps
are shown on the nameplate, simply multiply Volts by
the Amps to get Watts (Volts X Amps = Watts).
Some electric motors require about three times the
rated Watts of power for start-up. This surge of power is
required for only a few seconds. Be sure to allow for this
high starting wattage when selecting electrical devices
to connect to the generator.
First, figure the watts needed to start the largest motor.
Add to that figure the running watts of all other con-
nected loads.
Please see the Wattage Reference Guide.
It provides an estimated approximation of running watts,
to help determine which devices to select to connect to
the generator.
CAUTION! Do not tamper with engine governed speed.
The TITAN Generator supplies correct rated frequency
and voltage when running at the proper governed speed.
Incorrect frequency and/or voltage could damage con-
nected electrical devices.

GROUNDING THE GENERATOR

It is required by The National Electrical Code to have the
frame and all external conductive parts of the generator
connected to an earth ground. Proper grounding also
satisfies most local electrical codes.
Connect a No. 12 AWG standard copper wire to the
Grounding Lug Block (See Figure 1). The grounding
lug can be found on the front of the contorl panel. Con-
nect the other end of the wire to an earth driven copper
or brass grounding rod (electrode).
CAUTION! Do not connect ground to a preexisting
ground rod, water pipe, or building frame.
Consult with a licensed electrician in your area because
local codes vary. Properly grounding the generator helps
prevent electrical shock if a ground fault condition exists
in the generator or in connected electrical devices. This
will also help to dissipate static electricity resulting from
ungrounded devices.
3