Table 7-5 Configuring Netcapi - ZyXEL Communications Prestige 653HWI series User Manual

Prestige 653HWI Series User's Guide
LABEL
Active
Max Number of
Registered
Users
Incoming Data
Call Number
Matching
Start IP
End IP
Operation
Back
OK
Cancel
7.11.1 Configuring the Prestige as a NetCAPI Server
This section describes how to configure your Prestige to be a NetCAPI server.
By default, NetCAPI is enabled on your Prestige. When NetCAPI is enabled, the Prestige listens for
incoming DCP messages from the workstations. By default, the Prestige listens for DCP messages on TCP
port 2578.
The following figure illustrates the configuration used in this example.
7-16

Table 7-5 Configuring NetCAPI

Select this check box to enable NetCAPI.
When you want to use NetCAPI to place outgoing calls or to listen to incoming calls,
you must start RVSCOM on your computer, and RVSCOM registers itself to the
Prestige. Enter the maximum number of clients (no more than 5) for which you want
the Prestige to allow connections at the same time.
This field determines how incoming calls are routed. Select NetCAPI if you want to
direct all incoming data calls to NetCAPI. Select Subscriber Number (MSN) if you
want to direct all incoming call to the Prestige only when the incoming phone number
matches the ISDN DATA number. If the incoming phone number does not match the
ISDN DATA number, then the call will be routed to NetCAPI. Select Called Party
Subaddress if you want to direct all incoming calls to the Prestige only when the
incoming call matches the subaddress of ISDN DATA. If the incoming call does not
match the subaddress of ISDN DATA, then the call will be routed to NetCAPI.
Refers to the first IP address of a group of NetCAPI clients. Each group contains
contiguous IP addresses
Refers to the last IP address in a NetCAPI client group.
Select Incoming if you wish to grant incoming calls permission. Select Outgoing if
you wish to grant outgoing calls permission. Select Both if you wish to grant both
incoming calls and outgoing calls permissions. Select None if you wish to deny all
calls.
Click Back to return to the previous screen.
Click OK to return to the previous screen, then click OK to return to the next previous
screen and click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
WAN Setup