Dv Transmission To Your Camcorder - TerraTec Cameo 600 DV Manual

DV transmission to your camcorder.

When you have finished your first project, you may transfer it back to your camcorder (In this
case, your camcorder's DV input must be activated).
1. Connect one end of your DV cable to the Cameo 600 DV.
2. Start your camcorder and set it to Player – or VIR mode. Connect the other end of the DV
cable to the camcorder. Your system will automatically detect the camcorder's connection
to the computer.
3. Start the „Video Editor 6.0" from the program group „Ulead MediaStudio Pro 6.0 VE".
4. Open the video project that you want to transfer to your camcorder.
5. Select "File" in the "Video Editor. Next, choose "Device control"
6. Make sure that "MS 1394 Device control" has been selected.
7. Select "File" again, followed by "Transmit to tape" and choose "Time line".
8. Select "Whole Project" and click on "Options". Choose "Device control" and confirm your
entries by clicking on "OK". The transmission to your camcorder will now be started
automatically
If your computer does not use a Intel® Pentium® III 500-Processor
or higher, audio recordings may cause problems, while the "Transmit
to tape" feature for DV camcorders is used. We recommend you to
convert the whole project to a single DV video clip. After recording a
video from a DV camcorder, the audio section must possibly be
calculated again.
26 VideoSystem Cameo 600 DV (English)