Sample Program - Teledyne 7500 Instruction Manual

8. SAMPLE PROGRAM

This chapter concerns data read-out/write-in sample program which operates on N88-
Japanese BASIC (*2) for PC-9801 (*1) or compatible PCs.
Note that the program shown here is for reference for you to create a program and not for
guaranteeing all actions.
Before executing the program, make sure of the communication conditions in the following
procedure.
• Communication speed (baud rate):
Match the conditions with this instrument using SWITCH command and SPEED command
of MS-DOS (*3).
For SWITCH command and SPEED command, refer to the reference manual of MS-DOS.
• Data length, stop bits and parity:
Set in this program. Match the conditions with this instrument.
*1 PC-9801 series are products of NEC Corporation.
*2 N88-Japanese BASIC is a registered trademark of NEC Corporation.
*3 MS-DOS is a registered trade mark of Microsoft Corporation.
Teledyne Analytical Instruments
36