Network I/O; Remote Valve Connector - Teledyne 7320 Operating Instructions Manual

2 Installation
2.3.3.5
A serial digital input/output for local network protocol. At this printing,
this port is not yet functional. It is to be used in future options to the instru-
ment.
2.3.3.6
The 7320 is a single-chassis instrument, which has no Remote Probe
Unit. Instead, the Remote Valve connector is used as another method for
controlling external sample/zero/span gas valves. See Figure 2-7.
Figure 2-7: Remote Probe Connector Pinouts
The voltage from these outputs is nominally 0 V for the OFF and
15 V dc for the ON conditions. The maximum combined current that can be
pulled from these output lines is 100 mA. (If two lines are ON at the same
time, each must be limited to 50 mA, etc.) If more current and/or a different
voltage is required, use a relay, power amplifier, or other matching circuitry
to provide the actual driving current.
In addition, each individual line has a series FET with a nominal ON
resistance of 5 ohms (9 ohms worst case). This could limit the obtainable
voltage, depending on the load impedance applied. See Figure 2-8.
2-10

Network I/O

Remote Valve Connector

Teledyne Analytical Instruments
Model 7320