Rs-232 Port; Supporting Gases; Table 3-8: Commands Via Rs-232 Input; Table 3-9: Required Rs-232 Options - Teledyne 4040 Instruction, Operating And Maintenance Manual

3.3.4 RS-232 Port

The digital signal output is a standard RS-232 serial communications
port used to connect the analyzer to a computer, terminal, or other digital
device. It requires a standard 9-pin D connector.
Input: The input functions using RS-232 that have been implemented
to date are described in Table 3-7.

Table 3-8: Commands via RS-232 Input

Command
AS<enter>
AL<enter>
RL<enter>
RM<enter>
RH<enter>
RA<enter>
Implementation: The RS-232 protocol allows some flexibility in its
implementation. Table 3-9 lists certain RS-232 values that are required
by the Model 4020 implementation.

Table 3-9: Required RS-232 Options

Parameter
Stop Bits
Message Interval

3.3.5 Supporting Gases

Normally, four supporting gases of different composition (see
Section 4.1: Equipment) will be required to operate the analyzer. The
recommended composition of these gases is specified in the Application
Data section of the Appendix. The gases should be supplied from
cylinders that are equipped with the type of regulator specified in the
aforementioned sections.
Teledyne Analytical Instruments
Description
Immediately starts an autospan.
Immediately revert to Analyze (CH4 Mode)
Change to Manual Range LOW
Change to Manual Range MEDIUM
Change to Manual Range HIGH
Change to Manual Range AUTO
Setting
Baud 2400
Byte 8 bits
Parity none
1
Sent at the end of each cycle.
Installation
35