TAI Model 6400A SO
An example of an actual sequence of calibration status messages is:
C DDD:HH:MM IIII START MULTI-POINT CALIBRATION
C DDD:HH:MM IIII FINISH MULTI-POINT CALIBRATION
There are several methods of both checking the calibration and calibrating the 6400A, these are
discussed in Section 7. C LIST lists the calibration commands available. The C command
executes a calibration command, which may be one of the following:
Table 6-13: RS-232 Calibration Commands
Command
C LIST
C ZERO
C SPAN
C COMPUTE ZERO
C COMPUTE SPAN
C EXIT
C ABORT
C ASEQ X
6.8.6 DIAGNOSTIC Commands and Messages
When Diagnostic mode is entered from the RS-232 port, the diagnostic mode issues additional
status messages to indicate which diagnostic test is currently selected. Examples of Diagnostic
mode messages are:
D DDD:HH:MM IIII ZERO VALVE=ON
D DDD:HH:MM IIII ENTER DIAGNOSTIC MODE
D DDD:HH:MM IIII EXIT DIAGNOSTIC MODE
Analyzer Operator Manual, 02164, Rev. G
2
Description
List calibration commands
Start remote zero calibration
Start remote span calibration
Adjust remote zero calibration
Adjust remote span calibration
Terminate remote zero or span calibration
Abort calibration sequence
Initiate automatic sequence X if previously setup
6-20