Table of Contents
Advertisement
Trace Oxygen Analyzer
Installation
Installation of the Model 3000ZA Analyzer includes:
1. Unpacking
2. Mounting
3. Gas connections
4. Electrical connections
5. Installing the sensor
6. Testing the system.
3.1 Unpacking the Analyzer
The analyzer is shipped with all the materials you need to install
and prepare the system for operation. Carefully unpack the analyzer and
inspect it for damage. Immediately report any damage to the shipping
agent.
3.2 Mounting the Analyzer
The Model 3000ZA is for indoor use in a general purpose area. It is
NOT for hazardous environments of any type.
The standard model is designed for flush panel mounting. Figure 3-1
is an illustration of the 3000TA standard front panel (the 3000ZA is
similar) and mounting bezel. There are four mounting holes—one in each
corner of the rigid frame. Drawings at the back of this manual illustrate
the dimensions and mounting hole spacing for this unit.
On special order, a 19" rack-mounting panel can be provided. For
rack mounting, one or two 3000 series analyzers can be flush-panel
mounted on the rack panel. See Appendix for dimensions of the
mounting panel.
Teledyne Analytical Instruments
Installation
13
Advertisement
Table of Contents
