Installer Setup Menu; Advanced Settings; Installer Setup Numbers, Settings, And Tests (Table 4); Installer System Tests - Honeywell VISIONPRO TB8220U Installation Instructions Manual

WALL
Fig. 25. Mount thermostat to wallplate.

INSTALLER SETUP NUMBERS, SETTINGS, AND TESTS (TABLE 4)

MO TU
Inside
SYSTE
M
EM
HEAT
OFF
DONE
Fig. 26. Entering Installer Setup.
Installer
Setup Installer Setup
Number Name
0120 Date (Year Upper)
0130 Date (Year Lower)
0140 Date (Month)
0150 Date (Day)
0160 Schedule Options
TB8220U COMMERCIAL VISIONPRO™ PROGRAMMABLE THERMOSTAT
WE TH FR SA SU
Set To
Following
Schedule
CANC
M19923
Table 4. Installer Setup Menu.
Default
Setting All Settings
20 20—20xx
21—21xx
04 00-99
6 1-12
15 1-31 (Month Dependent)
4 0—Non-Programmable
4—Programmable

Advanced Settings

The thermostat has advanced settings to match the HVAC
system. These settings can be adjusted to match specific
needs. Access to these settings is obtained as follows:
1. From the main screen, press SYSTEM. Five blank
touch keys show on the bottom of the screen
between DONE and CANCEL.
2. Press and hold the two blank keys on either side of
the center blank key for approximately five seconds.
(See Fig. 26.)
3. The Setup Number displays to the lower-left area of
the screen. It is a four-digit code beginning with
zero. The current setting is displayed to the right.
NOTE: To cycle through the Setup Numbers, press the
up or down arrow.
M19919

Installer System Tests

Use the Installer System Test to test the heating, cooling
and fan. Refer to the latter portion of Table 4.
CAUTION
Equipment Damage Hazard.
Minimum compressor off time is bypassed
during Installer System Test
Avoid cycling compressor quickly.
IMPORTANT
Use Installer System Test to test heating, cooling
and fan. The setting chosen for System Type
(Installer Setup Number 0170) can prevent some
System Test Numbers from appearing.
Available year range: 2001 - 2178
Available year range: 2001 - 2178
9
Notes
62-3070—07