Important Notices - X-Micro XMP3-128 User Manual

Important Notices

(i) In OS Windows 98/98SE, if you don't set up installation firstly, system will
ask you to put driver disk for running installation. Be sure to unplug MP3
Player before running setup programs. If you install the driver with MP3
Player plugged, it may cause setup error or failure.
(ii) If you plug MP3 Player into the USB port. System can find MP3 Player, but
you are unable to access USB MP3. Please FORMAT MP3 Player.
(iii) Before unplugging MP3 Player from the USB port in Windows
ME/2000/XP, make sure you go to the right hand bottom of the screen to
stop the USB device. Otherwise, it may result in losing data that you
have saved on MP3 Player. (Please refer to 2.6.)
(iv) Linux uses a so-called "USB Manager", which does automatically load
kernel modules (drivers) for USB devices. It loads only drivers for devices
that are present on the USB bus to reduce memory usage. Per default,
the USB Manager does not come with the USB Drive pre-configured.
However, you can easily configure the USB Manager to automatically
recognize the USB Drive yourself.
configuration file,
usbmgr.conf (usually in /etc/usbmgr): vendor 0xd7d product 0x100
module scsi_mod, usb-storage
This line identifies the USB Drive and tells the USB Manager to load the
SCSI as well as the USB storage module. The SCSI module is needed in
order to talk to both SCSI and USB storage devices, while the usb-storage
module is needed to talk to USB storage devices.
Do not forget to either reload the USB Manager's configuration or to restart the
USB Manager (for instance, do as root: /etc/init.d/usbmgr reload).
：
Just add the following to the
18