Table of Contents Introduction 1.1 About X-Micro MP3 Player -----------------------------------------------------2 1.2 Features -----------------------------------------------------------------------------3 How to use X-Micro MP3 Player Mechanical parts------------------------------------------------------------------4 How to install battery-------------------------------------------------------------4 Function-----------------------------------------------------------------------------5 How to Install / Modify / Repair / Remove driver 3.1 Windows 98 / 98SE Installation ----------------------------------------------- 10 3.2 Modify or Repair driver for Windows 98 / 98SE---------------------------- 12...
1. Introduction 1.1 About X-Micro MP3 Player X-Micro MP3 Player is more than a USB MP3 Player. Being a smart customer, you pay for one MP3 Player price but enjoy double effects. Our MP3 Player stores not only USB MP3 format but also all kinds of data. It delicately combines USB MP3 Player with a removable hard drive.
1.2 Features Current available: 64MB / 128MB / 256MB - Support music format: USB MP3 - Earphone jack: 3.5 mm - Audio output: 5mW+5mW - Output frequency range: 20HZ – 20KHZ - Battery: Lithium-ION 500mA 3.7V, continue using player at least 20 hours at full-charge.
2. How to use X-Micro MP3 Player 2.1 Mechanical parts 2.2 How to install battery 1. Please connect MP3 Player to USB port to charge battery. When first time use it, please ensure charging time at least 1 hours and 45 minutes.
2.3 Function: USB MP3 player mode 1. Power on when earphone plugged and press for 3 seconds. (earphone port is 3.5mm) Play/Pause: Press Control Switch button once. Turn Off: Press Control Switch button for 3 seconds.
Page 7
Slide to right side and hold: volume raise Slide to left side and hold: volume low down Volume down Volume raise 4. Quick pull to right side: next song Quick pull to left side: previous song previous song next song...
Page 8
5. Power LED: (i) Orange LED on indicates battery in charge. Plug X-Micro MP3 Player into USB port to re-charge battery through computer. (ii) Green LED on indicates battery is in full charge. Power LED...
Page 9
6. Play LED: (i) Red LED indicates you are using USB MP3 player mode. (ii) Red LED quickly flashes when no USB MP3 file found. (iii) Red LED slowly flashes when you pause USB MP3 player. (iv) Green LED indicates you are using USB removable disk mode. (v) Green LED blinking when you are reading/writing from/on USB removable disk.
Page 10
7. To charge battery: take off cap and plug into USB port of notebook or desktop computer to charge battery. For better usage, please charge at least 1 hour and 45 minutes.
3. How to Install / Modify / Repair / Remove driver 3.1 Windows 98/98SE Installation: (1) Go to CD or floppy disk driver in “My Computer.” (2) Execute “Setup.exe” by double click on the icon. (3) Follow up the instruction by click “Next”.
Page 12
(4) System will install all the necessary files into your Windows operating system. After setup installation completed, click “OK” to restart computer. Once installation is finished completely, you can see a “Removable Disk” in “My Computer” when you plug MP3 Player.
3.2 Modify or repair driver for Win 98 / Win 98 SE (1) If you have installed the driver once before. When execute the “Setup.exe” file again, you will see the following screen. If somehow the driver is wrong or damaged, you can select “Repair”.
Page 14
(3) Click “Finish” to complete modification.
3.3 Remove driver from Win 98 / Win 98 SE (1) To remove driver from operating system. Execute the “Setup.exe” file from CD driver disk again. Select “Remove” and click “Next”. (2) System will then ask you to confirm deletion. Click “OK”. (3) This screen may or may not appear.
Page 16
(4) Click “Finish” to complete the process of removing device driver from system.
3.4 Windows ME / Windows 2000 / XP Installation For these three operating systems, NO Driver is needed, because Windows has built-in driver to support USB removable disk. Simply plug MP3 Player into the USB port and it will be recognized by the system. System will setup MP3 Player automatically without any further installation of driver.
5 Linux 2.4.0 + / Mac 8.6 + Installation Again, No Driver is required for these two operating systems. Simply plug the MP3 Player into the USB port and the system will automatically find MP3 Player. After using MP3 Player, you could unplug MP3 Player from the USB port directly once the LED stops blinking, then its icon would disappear automatically.
Important Notices : (i) In OS Windows 98/98SE, if you don’t set up installation firstly, system will ask you to put driver disk for running installation. Be sure to unplug MP3 Player before running setup programs. If you install the driver with MP3 Player plugged, it may cause setup error or failure.
Need help?
Do you have a question about the XMP3-128 and is the answer not in the manual?
Questions and answers