Operating Elements; Input Button (Press / Turn); Daytime Room Temperature" Button - Honeywell SDC Operating Instructions Manual

Operation
4.1.2.1
ð
4.1.2.2
¥
Setting
Factory setting
Setting range
14
4.1.2

Operating elements

Pos: 7 /156-Honeywell/Bedienung/Eingabeknopf @ 1\m od_1207643768135_6.doc @ 9240

Input button (press / turn)

By pressing once, you can:
• Confirm input / values
By pressing and holding (approx. 3 s), you can:
• Switch to the menu-selection level
• Move up one menu level
By turning the input button
• Change values (clockwise increases called-up values,
anticlockwise decreases them)
• Navigate through menus
Pos: 8 /156-Honeywell/Bedienung/Taste_Tages-Raum temperatur @ 1\m od_1207643818525_6.doc @ 9255

"Daytime room temperature" button

Sets the desired room temperature (room setpoint) in automatic
mode during the heating cycles and in the PARTY and HEATING
operating modes. In operating mode 1, the set value for all
heating circuits is the same. In operating mode 2, the set value
applies for the respective heating circuit. To set the operating
mode, see 4.2.3.3 Operating mode, pg. 52.
► Press ¥
► Set flashing room temperature specification to the desired
value by turning the input button
C
► Confirm set value by pressing the
î
button
Alternative: Automatic acceptance of the value after the set
information time (see 4.1.2.7 "System information" button, pg. 26).
20 °C
5 ... 30 °C
Pos: 9 /156-Honeywell/Bedienung/Taste_Nacht-Raum temperatur @ 1\mod_1207643918822_6.doc @ 9270
î
, you can:
button.
.
î
.
¥ button or the input
EN2H-0220GE51 R0308
SDC / DHC