Table of Contents
Advertisement
T7525/T7526 THERMOSTAT TOUCHPAD
Change the Operating Mode of Heating/Cooling Equipment
Base Screen
o
Warmer
Set:
C: 80
o
Actual:
80
Cooler
Options
Rate: NORMAL
Next
12:25PM Mon
First Options Menu
Options
Hold Temperature
More
Second Options Menu
Options
Run Schedule
Climate Control
Present Time/Day
More
Climate Control Menu
Climate Control
Settings and Schedules
Heat/Cool Equipment
Ventilation
Heat/Cool Equipment Menu
Heat/Cool Equipment
Change System
OFF
Change Fan
AUTO
On
Aux On
69-0860—1
Step 1
You can change the operating mode of heating and cooling equipment. Follow these
steps:
Select
1. From the Base screen, press the Options soft key. The screen displays the first
Options menu.
Back
2. Press the More soft key. The screen displays the second Options menu.
M8625A
3. Press the Climate Control soft key. The screen displays the Climate Control
menu.
Step 2
4. Press the Heat/Cool Equipment soft key. The screen displays the Heat/Cool
Equipment menu with the current operating mode highlighted.
Select
5. Perform one of the following:
Back
a.
To change the operating mode, repeatedly press the Change System soft
key until the desired operating mode displays (HEAT, COOL, and OFF for
M8626A
conventional systems and EM HEAT, HEAT, COOL, and OFF for heat
Step 3
pumps).
NOTE: For systems using the T7525C/T7526C Thermostat Touchpads
Select
NOTE: Select EM HEAT after a heat pump fault message (for example,
Back
M8627A
b.
To change the fan, repeatedly press the Change Fan soft key until the
Step 4
desired operating mode displays (AUTO and ON).
Select
6. Perform one of the following:
a.
To accept the changes, press the Select key. The screen displays the
Back
Climate Control menu.
b.
To cancel step 5, press the Back key within one minute. The screen
M8628A
displays the Climate Control menu.
Steps 5 & 6
7. Press the Select key. The screen displays the Options menu.
Select
8. Press the Select key. The screen displays the Base screen.
Back
M8631A
(auto changeover), an additional selection (AUTO) is available.
Heat Pump Failure) displays at the Touchpad. After the fault is
corrected, select one of the other operating modes.
8
USING THE TOUCHPAD
Advertisement
Table of Contents
