Advertisement
Table of Contents
INSTALLING AND OPERATING
YOUR MONTIGO 36DV-RV
GAS-BURNING FIREPLACE
Please leave this manual with the owner
CHECK LOCAL CODES PRIOR TO INSTALLATION
FOR YOUR SAFETY
IF YOU SMELL GAS:
1. OPEN WINDOWS.
2. DON'T TOUCH ELECTRICAL SWITCHES.
3. EXTINGUISH ANY OPEN FLAME.
4. IMMEDIATELY CALL YOUR GAS SUPPLIER.
READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING
CANADIAN HEATING PRODUCTS INC.
12091 88th Avenue, Surrey, B.C. Canada; Phone: (604) 597-3115 Fax: (604) 597-3096
01/94
MODEL
MONTIGO 36DV-RV
FOR YOUR SAFETY:
DO NOT STORE OR USE ANY FLAMMABLE
VAPOURS OR LIQUIDS NEAR THIS OR ANY
OTHER GAS-BURNING APPLIANCE.
Page 1 of 11
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Montigo 36DV-RV
Summary of Contents for Montigo 36DV-RV
- Page 1 INSTALLING AND OPERATING YOUR MONTIGO 36DV-RV GAS-BURNING FIREPLACE Please leave this manual with the owner CHECK LOCAL CODES PRIOR TO INSTALLATION FOR YOUR SAFETY FOR YOUR SAFETY: IF YOU SMELL GAS: 1. OPEN WINDOWS. DO NOT STORE OR USE ANY FLAMMABLE 2.
-
Page 2: Installing The Fireplace
The Montigo 36DV-RV clearances to combustible materials are 0" for Natural & Propane gas. back, 1" sides, 0" floor and 4" top. The Montigo 36DV-RV must not The Montigo warranty will be voided by, and Montigo disclaims be installed any closer than 8 inches to any unprotected any responsibility for, the following actions: combustible wall perpendicular to the fireplace opening. -
Page 3: Installing The Gas Line
FOR DETAILED SKETCH OF ALLOWED TERMINATION LOCATIONS SEE APPENDIX A The gas line must be installed before finishing the Montigo 36DV-RV Fireplace. Natural Gas requires an inlet pressure of 7" W.C. & a manifold pressure of 3.5" W.C. Propane Gas FOR VINYL SIDING APPLICATIONS ALL ETK requires an inlet pressure of 11"... -
Page 4: Installing The Remote Switch
VENTING OF REAR VENT DV 3). 45 corner kit. Use a 45 elbow, stucco frame and a 5" The Montigo 36DV-RV has been designed for four possible termination. (see figure 7). rear vent installations. 1). Standard 4" or 6" stud walls. For 4" walls use a stucco frame and a 5"... -
Page 5: Mantels And Surrounds
FIREPLACE MANTEL AND FACING MANTELS & SURROUNDS NOTE: National Canadian Gas Association mantel test Combustible mantels and mouldings may be safely installed over requirements are for fire hazard prevention to combustible the top and on the front of the fireplace provided that they do not materials. -
Page 6: Installing Log Set
INSTALLING LOG SET Easily removed for cleaning and servicing. Although this pane is The Montigo 36DV-RV is supplied with four(4) very attractive made of a very tough tempered glass, always handle it carefully and cultured oak logs. To install simply place log “A’s” rectangular place in a safe location where it will not be broken or damaged. -
Page 7: Pilot Burner Adjustment
It is imperative that burner control compartments, burners and circulating air passageways of the appliance be kept clean. For If your Montigo 36DV-RV still does not operate correctly, consult your convenience a 1/8" pressure tap is supplied on the gas valve your dealer or the manufacturer. - Page 8 Canadian Heating Products Inc. warrants the Montigo 36DV Decorative Gas Appliance to be free from defects in materials and workmanship at the time of manufacture. On the Montigo 36DV there is a ten-year warranty on the firebox and its components, a five-year warranty on the main burner, pilot burner and cultured oak logs, and a one-year warranty on the gas control valve and glass doors.
Need help?
Do you have a question about the 36DV-RV and is the answer not in the manual?
Questions and answers