Monster SUPERTHIN Installation Manual And Warranty
Large articulating mount
Hide thumbs
Also See for SUPERTHIN:
- Installation manual (20 pages) ,
- Installation manual and warranty (20 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Installation Manual
Advertisement
Table of Contents
Related Manuals for Monster SUPERTHIN
Summary of Contents for Monster SUPERTHIN
-
Page 1: Installation Manual
SUPERTHIN LaRgE aRTIcULaTINg MOUNT ™ SECURE, EASY TO INSTALL, LOW-PROFILE MOUNT WITH EXTENDING SWING ARMS INSTaLLaTION MaNUaL aNd waRRaNTy " " lbs. (106-160cm) (54.43kg) -
Page 2: Safety Warning
SUPERTHIN LaRgE aRTIcULaTINg MOUNT ™ This SuperThin mount is designed to mount 42"– 63" (106 – 160 cm) flatscreen televisions to vertical walls. Maximum weight capacity is 120 lbs. (54.43 kg). SaFETy waRNINg If you don’t understand these directions, or are Before installing, carefully review the instructions to ensure that no parts are missing or defective. - Page 3 9.01" (22.9cm) 25" (63.5cm) 8.58" (214cm) 18.78" (47.4cm) Specifications and Notes VESA 200×200 / 300×300 / 400×200 / 400×400 / 600×400 / 800×400 Compliant ™ Monster is constantly striving to improve its products. Specifications are subject to change without notice.
-
Page 4: Package Contents
4 each M6×10 / M6×15 / M6×25 4 each M8×10 / M8×15 / M8×25 1 Electronic 2 Allen Keys 1 Hex Wrench Studfinder Package contents If any parts are missing, please call the appropriate Monster number for your location. See page 2 for phone numbers. -
Page 5: Read Before Installing
(5) DO NOT install in a location where there is anchors) are included, masonry mounting requires excessive dust, smoke or moisture. These sources specialized knowledge, skills and tools. Monster can create a fire. highly recommends that you seek the assistance of a professional installer when mounting to masonry. -
Page 6: Required Tools
Above tools from any source of heat or water. Replace ³ ∕ ₁₆ " drill bit with ½" masonry drill bit Hammer TIP: To hide your TV’s power cord and AV cables, install a Monster FlatScreen CleanView Cable ™ ™... - Page 7 Installing the wall Mounting Plate Remove all pieces of the wall mounting system to ensure you have all necessary parts. adjust wall Plate Location With supplied Allen key, loosen bolts on wall plate and position wall plate in the desired sliding slots of wall plate rails.
- Page 8 wood Stud Mounting An electronic studfinder is included. Remove plastic tab on the back of the studfinder to activate battery. To locate a wall stud, hold the studfinder against the wall where you want to mount your TV. Push down the button on the studfinder and slide the studfinder along the wall until the indicator light goes on.
- Page 9 wood Stud Mounting (cont’d) With your electric drill and ³ ∕ ₁₆ " bit, pre-drill a 3" deep hole where indicated on template. After drilling holes, remove template from wall. Position the wall mounting plate rails over the holes drilled in the wall studs. Make sure the wall plate rails are level by using the supplied bubble level.
- Page 10 wood Stud Mounting (cont’d) With the help of another person, attach the wall plate to the wall using the lag bolts and round washers as shown to the right. Tighten each bolt with your wrench. Turn clockwise until secure. Continue to page 14 to continue your installation. DO NOT over tighten bolts.
- Page 11 Masonry Mounting Masonry mounting requires specialized knowledge, skills and tools. Monster highly recommends that DO NOT drill holes in masonry you seek the help of a professional installer when mortar joints. mounting to masonry. Position the supplied cardboard template in the desired location and tape template to wall with masking tape.
- Page 12 Masonry Mounting (cont’d) Install the supplied plastic concrete anchors in each hole. Tap into hole with hammer until fully seated. Position the wall mounting plate rails over the holes drilled in the wall studs. Make sure the wall plate rails are level by using the supplied bubble level.
- Page 13 Masonry Mounting (cont’d) With the help of another person, attach the wall plate to the wall using the lag bolts and round washers as shown to the right. Tighten each bolt with your wrench. Turn clockwise until secure. DO NOT over tighten bolts. This can DO NOT release the wall plate until damage the wall plate or the surface of you are absolutely sure it is secured to...
- Page 14 attaching your Flatscreen TV to the TV Mounting Brackets DO NOT lay your TV face down when attaching the TV mounting brackets. The television should be unplugged This can cause permanent damage before threading any bolt or screw into to your screen. Lean it against a wall the back panel.
- Page 15 Hanging your Flatscreen TV on the articulating arm With the help of another person, lift your TV up to mount level. Raise the TV just above the center plate on the end of articulating arm. Hang brackets from appropriate keyholes on center bar depending on bracket spacing and desired height.
- Page 16 adjusting the Flexibility of the Tilt Mechanism Using the supplied Allen key and hex wrench, adjust the bolts on the side of the articulating arm where it connects to the center plate to desired feel of the tilt mechanism. To adjust tilt angle, gently pull top of TV while pushing the bottom to the desired position up to 12°.
- Page 17 Routing your TV’s Power cord and aV cable through the cable Management System With the mount completely installed on the wall and your TV properly secured to the mount, fully extend the mount’s articulating arm. Connect your TV’s power cord to the TV (if TV uses a detachable-type power cord).
- Page 18 NOTE: DO NOT run power and AV cables in the same channel, as this may cause electrical interference that can affect picture and sound quality. congratulations You’ve successfully installed your Monster SuperThin FlatScreen Mount. ™ Visit us at www.MonsterCable.com/FlatScreen for more innovative Monster FlatScreen products.
- Page 19 Ultra-soft for easy routing and installation. Exclusive Monster MicroFiber cloth won’t scratch delicate screen patented technologies deliver the advanced coatings. performance you need from your flatscreen TV. For more details on all our Monster FlatScreen products, visit us at MonsterCable.com/FlatScreen...
-
Page 20: Limited Warranty For Consumers
(including without transferred ownership of the Product, whichever occurs limitation building and/or electrical codes), (iv) in earlier. Also, You must call Monster and obtain a Return accordance with manufacturer recommendations and / Authorization Number (as described under “How to or instructions in the materials and documentation that Make a Claim”) within two (2) months after You discover... - Page 21 If a repair estimate is required, You will be English version shall prevail. instructed on how to properly submit the estimate and the resulting invoice to Monster for payment. Any fees for REGISTRATION. Please register Your Product at repairs may be negotiated by Monster.