Figure 2-1: Installing The R17S Sensor; Figure 2-2: Sensor Cable Connection To Monitor - Teledyne MD300 Operating/Service Instructions Manual

Operation
WARNING: THE SENSOR ELECTROLYTE IS CAUSTIC. DO NOT
LET IT COME IN CONTACT WITH SKIN. IF IT DOES,
FLUSH AFFECTED AREA WITH WATER. DO NOT
ATTEMPT TO OPEN OR REPAIR THE SENSOR.
2. Plug one end of the coiled cable into the jack receptacle on the
back end of the R17S sensor and secure in place with the capture
nut located at the base of the connector. See Figure 2-1.

Figure 2-1: Installing the R17S Sensor

3. Plug the other end of the coiled cable into the receptacle located on
the right side of the unit and secure it in place using the capture nut.
See Figure 2-2.

Figure 2-2: Sensor Cable Connection to Monitor

Teledyne Analytical Instruments
AD300/MD300
14