ActionTec V1000H User Manual page 24

Wireless vdsl modem router

Hide thumbs Also See for V1000H:

Table of Contents

To change the radio settings of the Modem Router's wireless network (if needed;

you do not need to make all the changes in this procedure, as they can be changed

independently of each other):

Select the radio's channel from the Channel drop-down list.

Select the level of the wireless radio's power level.

Select the wireless network's mode. Options include whatever mix of 802.11b,

g, and n modes you prefer (except b/n only).

Select the channel width by clicking in either the 20 Mhz or 40 Mhz

radio buttons.

If 40 Mhz was selected in step 5, select the channel's width (

Set the MSDU (MAC-Layer Service Data Unit) aggregation state by clicking

in the Enable or Disable radio buttons below step 6. MDSU should only be

enabled/disabled by an experienced network technician.

Set the MPDU (MAC-Layer Protocol Data Unit) aggregation state by clicking

in the Enable or Disable radio buttons below step 7. MPDU should only be

enabled/disabled by an experienced network technician.

Apply.

Click

Chapter 3 Wireless Settings

Upper or Lower).

Table of Contents

Show Quick Links

Table of Contents