Table of Contents
Advertisement
CONNECTION WITH SCSI DATA SIGNAL EQUIPMENT
SCSI interface is available if optional SCSI board is installed. SCSI board is installed at the rear option slot of the unit. See the
operations manual of the optional SCSI board.
Make sure to turn off the power before installing the option board.
(EXAMPLE)
PC, etc.
1 1 1 1 1
Connect the unit with PC through SCSI cable.
2 2 2 2 2
Set the slide switch in the printing unit to "OPTION (SCSI)".
2 2 2 2 2
SETTING SCSI ID SWITCHES
Set the SCSI ID switches (SCSI ID) on the rear panel according to the connected
equipment.
•
When shipping, SCSI ID is set to No. 5.
•
No.7 is provided for personal computer you use and No. 0 for built-in hard disk (of
Macintosh).
•
When another SCSI device is connected to the personal computer, make sure to set
the SCSI ID of this unit to a different ID#.
•
Select the SCSI ID number to between 1 and 6 (for Macintosh) or 0 and 6 (for
Windows
95/98).
®
When this unit is not connected to other equipment except the host computer , terminate
the port with the terminator supplied with optional SCSI board.
To SCSI port
To SCSI port
(When not connecting to
other equipment, the terminator
is required.)
Terminator
SCSI
SCSI ID
SCSI
ON
8
7
6
5
4
3
2
1
OFF
8 7 6 5 4 3 2 1
PARALLEL DATA IN
AC LINE
SCSI ID switch
NOTE
11
Advertisement
Table of Contents
