Mitsubishi Electric CP30DW Operation Manual page 12

SAFETY PRECAUTIONS
PROTECT AGAINST DEW FORMATION
When the unit is moved from a cold area into a warm area, moisture can condense inside the unit
and prevent operation. Allow the temperature to stabilize before use.
When print paper and ribbon cartridge are loaded, remove them.
Replace the wet print paper and ribbon cartridge with new ones.
OPERATING AMBIENT TEMPERATURE RANGE
The operating temperature range is 41°F - 104°F (5°C to 40°C) and humidity of 30 - 80% RH.
When using the unit in a system rack, make sure that the temperature inside the rack does not
exceed this range.
UNSUITABLE MATERIALS FOR THE PRINTER
Paint coat flaking and plastic deformation are likely to occur if the unit is wiped with chemical
dusters, benzene, thinner or any other solvent, if rubber or PVC items are left in contact with the
unit for a extended period, or if the unit is sprayed with insecticide.
CARE OF THE CABINET
Unplug and clean with a soft cloth slightly moistened with a mild soap and water solution. Allow
to dry completely before operating. Never use petroleum based solutions or abrasive cleaners.
HEAD ABRASION
The thermal print head, like a video head, wears out. When it is worn, it becomes hard to print
out fine details of the picture. If it occurs, consult your dealer about having the head replaced.
CONNECTING DEVICES
Read thoroughly the Safety Notices, Cautions and Operating Precautions of the instruction
booklets for the other devices connected with the unit.
CAUTION ON RELOCATING
When transporting the unit, make sure it is not likely to be subjected to impacts. This can be a
primary cause for damage. Before moving the unit, make sure to disconnect the power cord
from the power outlet, and the cables from the connected devices.
Periods: According to the recommendations of the manufacturer of medical device.
Scope: a) Visual inspection
Housing, leads, controls, displays, labels/ markings, accessories, operation manual.
b) Functionality test
Testing of functions (according to operation manual) as well as compatibility and
usability of device and accessories.
c) Electrical test
Testing of electrical safety of the system according to EN60601-1.
High humidity or dust
Avoid locations with high humidity and dust in order to avoid malfunction.
Also avoid locations subject to corrosive gasses and smoke.
Heat
Direct sunlight, heaters or other heat sources may deform the housing and subsequently cause
malfunctioning.
4
FOR LONG OPERATING LIFE
SAFETY TECHNICAL CHECKS