Error Indications - Mitsubishi Electric DX-NV100E Installation And Operation Manual

Error indications

When an error occurs in the recorder, the log is registered in the log list. To clear the alert, press the CANCEL button.
*1 : Alert level
Minor : Check the cause of the alert. By clearing the alert, you
can keep using the recorder. If the same alert appears
frequently, contact your dealer.
Major : Contact your dealer.
<Error log>
LOG display
LOG number example in the
client software
5100 LOG5100
5101 LOG5101
5121 LOG5121
9900 LOG9900
6100 LOG6100
6200 LOG6200
6400 LOG6400
1400 LOG1400
2400 LOG2400
1500 LOG1500
1600 LOG1600
1300 LOG1300
2300 LOG2300
54 *2 LOG54
20
Cause
• The recorder is rebooted.
• The recorder is rebooted for watchdog
operation.
• The HDD management information is
damaged.
• No HDDs can be recognized.
• No internal HDDs can be recognized.
• The HDD cannot be recognized during
mirroring mode.
• An error occurs during recording.
• An error occurs during data acquisition.
• An error is detected in the data stored in
the HDD.
• An error occurs during writing/reading
the HDD.
• The HDD is exposed to vibrations and
shocks.
• The IP camera is not connected correctly. • Press the CANCEL button on the
*2
*2 : (The following numbers are displayed in
01 : CH 1 02 : CH 2
05 : CH 5 06 : CH 6
09 : CH 9 10 : CH 10
13 : CH 13 14 : CH 14
Remedy
• Press the CANCEL button on the
front panel to clear the alert.
-
-
• Check whether the HDD has no
malfunction.
• Turn off the power of the recorder
and then turn it back on.
• Check the connection.
• Contact your dealer.
• Check whether the HDD has no
malfunction.
• Turn off the power of the recorder
and then turn it back on.
• Check the connection.
• Check whether the HDD has no
malfunction.
• Start the operation again.
• Turn off the power of the recorder
and then turn it back on using the
POWER button on the front panel.
• Turn off the power of the recorder
and then turn it back on using the
MAIN switch on the rear panel.
• Press the CANCEL button on the
front panel to clear the alert.
• Check the HDD.
• When no abnormality is found, you
can keep using the recorder.
• When errors occur repeatedly, check
the HDD and cables and reboot the
recorder.
front panel to clear the alert.
• Check whether the recorder and
camera are connected correctly and
turned on.
.)
03 : CH 3 04 : CH 4
07 : CH 7 08 : CH 8
11 : CH 11 12 : CH 12
15 : CH 15 16 : CH 16
Call-out
Alert
signal
level*1
output
Output Minor
Output Minor
Output Minor
Output Minor
Output Major
Output Minor
Output Minor
Does not Minor
output
Does not Minor
output
Does not Minor
output
Output Minor