Set Parameter - Mitsubishi Electric RS232/485/LAN Serial Communication Control Manual

00h: No Error.
01h: Unsupported operation with this monitor or unsupported operation under current condition.
This result code from the monitor is encoded to ASCII characters.
Ex.) The byte data 01h is encoded to ASCII character '0' and '1' (30h and 31h).
th th
4 –5 bytes) OP code page: Operation code page.
These bytes indicate a replying item's OP code page.
This returned value from the monitor is encoded to ASCII characters.
Ex.) The byte data 02h is encoded to ASCII character '0' and '2' (30h and 32h).
Refer to the operation codes table.
th th
6 –7 bytes) OP code: Operation code
These bytes indicate a replying item's OP code.
This returned value from the monitor is encoded to ASCII characters.
Refer to the operation code table.
Ex.) The byte data 1Ah is encoded to ASCII character '1' and 'A' (31h and 41h).
th th
8 -9 bytes) Type: Operation type code
This returned value from the monitor is encoded to ASCII characters.
Ex.) The byte data 01h is encoded to ASCII character '0' and '1' (30h and 31h).
00h: Set parameter
01h: Momentary
Like the AutoSetup function which automatically changes the parameter.
th th
10 -13 bytes) Max. value: Maximum value which monitor can accept. (16bits)
This returned value from the monitor is encoded to ASCII characters.
Ex.) '0','1','2' and '3' means 0123h (291)
th th
14 -17 bytes) Current Value: (16bits)
This returned value from the monitor is encoded to ASCII characters.
Ex.) '0','1','2' and '3' means 0123h (291)
th
18 byte) ETX: End of Message
ASCII ETX (03h)

5.3 Set parameter

OP code page
STX
Hi Lo
st nd rd
1 2 -3
Send this message to change monitor's adjustment and so on.
The controller requests a monitor to change value.
st
1 byte) STX: Start of Message
ASCII STX (02h)
nd rd
2 -3 bytes) OP code page: Operation code page
OP code Set Value
Hi Lo MSB
th th th th
4 -5 6 -9
(14/56)
ETX
LSB
th
10