Table of Contents
Advertisement
1 2
• Position the handlebar upright.
• Fit the handlebar neck to the bottom of the handlebar.
• Insert two #10 x 1
/
5
8
handlebar neck.
• Fit a #10 lock nut onto the ends of both screws. Make sure the
rounded side of the lock nut is down.
• While holding a lock nut steady with an adjustable wrench
(or pliers), tighten the screw. Repeat this procedure to tighten
the other screw.
• Set the handlebar assembly aside for assembly step 17.
Lower Steering
Linkage
1 3
• Lift the front end of the vehicle.
• Slide the straight end of the steering column through the
hole in the upper steering linkage and out through the hole
in the vehicle.
• Insert the curved end of the steering column into the hole in
the lower steering linkage.
12
Handlebar
Handlebar
Neck
#10 Lock Nuts
" screws down through the handlebar and
Steering
Column
Upper Steering
Linkage
Bottom View
ASSEMBLY
Rounded
Side
1 4
• Fit the steering column cap on the curved end of the
steering column.
• While supporting the steering column, insert a #8 x
into the large hole in the steering column cap and tighten.
Hint: You may need the help of another adult to support the
other end of the steering column while you insert and tighten
the screw in the steering column cap.
• Lower the front end of the vehicle.
Hole
1 5
• Slide the steering bushing, narrow side down, onto the
steering column and into the vehicle neck.
Steering
Column
Steering
Column Cap
Steering Bushing
Steering
Column
Top View
3
/
" screw
4
R1502b-0920
R1502b-0920
Advertisement
Table of Contents
