Summary of Contents for Fisher-Price Robotz Rescue Heroes Hyper Jet HQ
Page 1
Figures sold separately and subject to availability. Instructions: C5959 Please keep this instruction sheet for future reference, as it contains important information. Requires three “C” (LR14) and three “AAA” (LR03) alkaline batteries (not included). Adult assembly is required. Tool required for battery installation: Phillips screwdriver (not included).
Page 2
Parts 2 Rear Landing Gear (Larger) Mission Central Console Jet Body Glider Wing Front Landing Gear (Smaller) Space Pod 2 Glider Supports Stretcher Tough Terrain Vehicle Cargo Door 2 Wings Keytron™ Robot 2 Water Missiles Hose Ramp Water Cannon Launcher Not Shown: Label Sheet...
Page 3
Building the Hyper Jet ™ Front Landing Hose Gear (Smaller) Rear Landing Gear (Larger) • “Snap” the hose into the hole in the cargo bay. • Position the jet body with the bottom facing you. Ramp • “Snap” the smaller front landing gear into the jet body.
Page 4
Building the Hyper Jet ™ Mission Central Console Groove Cargo Door • Position the cargo door near the back of the jet with the ramp facing up. • At an angle, fit the right side door peg into the right hole in the jet body •...
Page 5
Building the Hyper Jet ™ Glider Wing Space Pod • Fit the glider wing onto the two pegs on the glider supports. • Press and hold the latch on the jet body. • The glider wing is removable and will attach to the •...
Label Decoration ® ® ® ® • Make sure the areas where the labels will be applied are clean and dry. Apply the labels as shown in the illustration above. • For best results, do not attempt to apply a label more than once.
Page 8
Battery Installation - Mission Central Console • Locate the battery compartment on the back of the Mission Central Console. • Loosen the screws in the battery compartment door with a Phillips screwdriver. Remove the battery compartment door. • Insert three “C” (LR14) alkaline batteries as indicated inside the battery compartment.
Battery Safety Information Batteries may leak fluids that can cause a chemical burn injury or ruin your toy. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or recharge- able (nickel-cadmium).
Page 10
™ Build the Hyperbot Figures sold separately and subject to availability. Space Pod • Press the latch on the jet body to detach the • Open the canopy and slide a figure into the cockpit. space pod. • Rotate the “arms” towards the front of the space pod. •...
Page 11
To the Rescue! Launch the Using the Water Cannon! Glider Wing • Insert a water missile into the slot in the water cannon. • Press the button on top of the cannon to launch the missile. IMPORTANT! Only use projectiles supplied with this toy.
On Board Storage • Close the rear cargo door. • Rotate the Mission Central Console into the cargo bay. • Place the stretcher and tough terrain vehicle into the • Reattach the glider wing. cargo bay as shown. • Slide the two loading ramps into the jet.
Page 13
™ Welcome Aboard the Hyper Jet Figures sold separately and subject to availability. Hear Keytron or Warren Waters assign missions to the crew on the Mission Central ™ ™ Screen. Just connect the tethered backpacks to your Robotz figure and minibot and press the mission button in the center of the screen to start the adventure! ™...
Page 14
Keytron ™ has a Mission for the Team! Mission Button Attach a Roboz figure and a Robotz minibot to the tethered backpacks. Press the Mission button to hear a conversation between the attached figures and either Warren Waters™ or Keytron™ (if attached). If the light under the button is blinking, press again to hear more about the mission.
Care • Wipe this toy with a clean damp cloth dampened with a mild soap and water solution. • Do not immerse this toy. FCC Note (United States Only) Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Need help?
Do you have a question about the Robotz Rescue Heroes Hyper Jet HQ and is the answer not in the manual?
Questions and answers