Table of Contents
Advertisement
３-１ Setting the Weighing Instrument and the AD-8922A
1. Set each item as shown below. Set the same value for the weighing instrument and the AD-8922A.
Item
Baud rate
Data bits, Parity bit
Stop bits
Terminator
Data format
Communication control
Data output mode
Items in bold face type: Factory settings for both the AD-8922A and the weighing instrument.
* When connected to an external device, the settings can be changed to suit the use.
2. Set the command set "
in "1-2 Applicable Instruments".
Note: Some items may not be available for the instrument used. For details on setting, refer to
the instruction manual of each weighing instrument.
When connected to an external device such as a personal computer or a printer, set the output
out
mode "
weighing instrument, appropriate to the use. (See Table 3 in "3-5 Example of Use".)
３-２ Connecting the AD-8922A
For information on cables required for connection, see Table 1 in " 1-2 Applicable Instruments".
Connect the weighing instrument to the AD-8922A D-Sub 9-pin connector.
Connect an external device such as a personal computer or a printer to the AD-8922A DIN 8-pin
connector.
３ GETTING READY
C5et
" of the function setting, appropriate to the weighing instrument. See Table 2
Hold
" and time out "
" of the function setting, and set the data output mode of the
Table 3
Weighing instrument
600, 1200, 2400, 4800, 9600. 19200 bps
7 bits - EVEN, 7 bits - ODD, 8 bits - NONE
1 bit or 2 bits
<CR> or <CR><LF>
A&D standard format
No RTS/CTS control
Stream mode*
6
AD-8922A
⎯
⎯
⎯
Advertisement
Table of Contents
