Table of Contents
Advertisement
１１-３ Setting the Upper and Lower Limit Values
Up to 10 set of upper and lower limit values can be stored.
Using the stored upper and lower limit values, comparison can be performed easily. To recall the
stored values, press and hold the ON:OFF key and press the MODE key.
１１-３-１ Storing the upper and lower limit values
To store new upper and lower limit values, recall the stored data ("C01" to "C10") and change them.
1. While pressing and holding the ON:OFF key, press the RE-ZERO key to enter the confirmation
mode. The upper limit value data (Comparator number and the upper limit mass (blinking)) of the
comparator number that was selected last.
Displaying example
2. Select the comparator number using the following keys.
RE-ZERO key
MODE key
Each time the key is pressed, the upper limit value and the lower limit value of the comparator
number selected is displayed alternately. (
3. Press the SAMPLE key to go to the storing mode to change the stored values.
Digital input mode
SAMPLE key
RE-ZERO key
MODE key
ON:OFF key (press and hold) MODE key
PRINT key
CAL key
4. Press the CAL key to return to the weighing data
display.
To increase the comparator number by 1.
To decrease the comparator number by 1.
C01
To select the digit to change
the value.
To change the value of the
digit selected.
To move the decimal point
position to the right by 1
digit.
To switch the polarity.
To store the new setting and
return to step 2.
To cancel the new setting
and return to step 2.
C01
C02
HI ⇔
LO ⇔
28
C02
HI ⇔
LO ⇔...)
Advertisement
Table of Contents
