Operation Of Winct-Ad4212C - A&D AD-4212C-300 Instruction Manual

4. OPERATION OF WinCT-AD4212C

The software has the following functions:
- Set the weighing speed
- Set the minimum display value
- Calibration
- Set the baud rate
• The parameters set using these functions, are stored in non-volatile memory, and maintained,
even if the AC adapter is removed,.
- A data logging function, allows confirmation of the weighing data after weighing
Before use
1. Install the WinCT-AD4212C into the computer. For details, refer to Readme of WinCT-AD4212C.
2. Connect one end of the RS-232C cable to the weighing unit RS-232C connector and connect
the other end of the RS-232C cable (D-sub 9-pin) to the personal computer RS-232C terminal.
3. Set the COM port of the WinCT-AD4212C on the personal computer, and press the START
button. The personal computer will display the weight value.
Function of display symbols and buttons
Processing indicator
Stabilization indicator
Standby indicator
Button
Switches between the weighing mode and the standby mode. With the standby mode,
only the standby indicator is displayed. The ON/OFF button is available anytime.
ON/OFF
Therefore, if you press the ON/OFF button when operating, the balance switches to the
standby mode.
SAMPLE In the weighing mode, switches the minimum weighing value.
MODE Changes the weighing speed.
CAL Enters the calibration mode.
PRINT (Usually no function. Used in the calibration mode.)
RE-ZERO Sets the display to zero.
Weighing speed indicators
Unit (g)
Weighing data or stored data
When pressed
15