Table of Contents
Advertisement
Playing a Clip from the GUI
All three server channels can play video, individually or simultaneously. Channel 1 can record
or play, but not both at once. Follow these steps to play back a clip.
Beginning Playback
1. Select FILE >OPEN from the Transport Window of Channel 1, 2 or 3. The Clip Navigator
shown in Figure 9 will appear.
2. Navigate the folder structure if necessary by clicking on the folders.
3. Select the clip you want to play by double-clicking on it.
4. When the Transport Window indicates Idle Ready, you can play the clip at any time by
clicking PLAY.
Looping a Clip
Clicking on the LOOP checkbox in the Transport View will cause a clip to loop until LOOP is
unchecked or until you click STOP. LOOP may be checked or unchecked before or during
playback, but must be changed at least 2 seconds before the end of clip to take immediate effect.
Pausing a Clip
Click PAUSE at any time to pause a clip. Click again to resume. The PAUSE button is the same
key as the PLAY button.
MAXX-1200 Owner's Manual
Figure 9 - Channel 1 Clip Navigator in "Open" Mode
Page 45
Advertisement
Table of Contents
