Table of Contents
Advertisement
Rebuilding the RAID Array
Figure 45: Selecting a Drive to Use in Rebuilding the Array
•
Select Rebuild Unit. The dialog above will appear.
•
Select the available drive by clicking the check box.
•
Press OK. The RAID array will begin rebuilding with the new drive. This process may take a
long time, but the server can still be used.
•
When complete, OK will be shown in the status for all ports on the Maintenance menu.
Replacing Hard Drives
The server hard disk drives have been factory tested and configured in a RAID 5 array. Each drive
is numbered (0-3) and must be attached to the correctly numbered data cable. Drive bays are also
numbered.
Please read Removing the Front Panel on page 114 for instructions on accessing the hard drive
bays. Detailed information about how to replace hard drives is on page 118.
MAXX-1200 Owner's Manual
Page 109
Advertisement
Table of Contents
