Sharp PC-AR10 Manual page 55

Supporting System Hibernate
To support System Hibernate mode, you need to perform the following:
1. In the Power Options properties dialog box, select Hibernate tab.
2. Check Enable hibernate support.
3. Click Apply and OK.
Entering System Standby/Hibernate
Your computer will enter System Standby/Hibernate under several sets of conditions
as follows:
The System stand by/System hibernate timeout in the Power Options properties
3 3
dialog box elapses.
Hot keys Fn+F12 are pressed.
This functions if you perform the following:
1. In the Power Options properties dialog box, select Advanced tab.
2. Select Hibernate or Stand By in When I press the sleep button on my
computer.
3. Click Apply and OK.
The upper cover is closed when no external monitor is connected to the
computer.
This functions if you perform the following:
1. In the Power Options properties dialog box, select Advanced tab.
2. Select Hibernate or Stand By in When I close the lid of my portable
computer:
3. Click Apply and OK.
The power button is pressed.
This functions if you perform the following:
1. In the Power Options properties dialog box, select Advanced tab.
2. Select Hibernate or Stand By in When I press the power button on my
computer.
3. Click Apply and OK.
You select Stand by/Hibernate in Shut Down Windows dialog box.
Resuming from System Standby/Hibernate
Resuming from System Standby
Your computer will resume from System Standby if you operate the computer again.
Resuming from System Hibernate
Your computer will resume from System Hibernate if the power button is pressed.
3-10