Battery Installation - Fisher-Price POWER WHEELS 78475 Owner's Manual & Assembly Instructions

H
Important Note: Use only a Power Wheels
with an A-style connector and built-in thermal fuse. Use of
any other battery may damage your vehicle. Make sure that
you charge the battery for at least 18 hours using the
enclosed Power Wheels ® Super 6
connector before operating your vehicle for the first time.
Charge the battery for at least 14 hours after each use of
the vehicle. Never charge the battery longer than 30 hours.
Failure to follow these instructions may damage your battery
and will void your warranty.
1
Seat
Vehicle
Body
• Press in on each side of the seat (near each tab) and lift
the front of the seat.
• Remove the seat.
2
Battery Motor Harness
Connector Connector
• Place the battery upright in the battery compartment.
• Plug the battery and motor harness connectors together.
Push firmly to plug the two connectors together.

Battery Installation

® 6 volt battery
™ Volt charger with A-style
PUSH HERE
PUSH HERE
Battery
3
Battery Retainer
• Insert the ends of the battery retainer into the holes in the
front of the battery compartment.
4
#10 Washer
Carriage Bolt
• Lower the battery retainer over the batteries.
• Fit the carriage bolt up through the hole in the underside
of the vehicle body and through the end loop in the
battery retainer.
• Fit the #10 washer onto the carriage bolt.
• Fit the wing nut onto the carriage bolt.
• Tighten the wing nut. Do not over-tighten.
5
Seat
Tabs
• Fit the hooked tabs on the back of the seat into the slots
in the back of the vehicle body.
• Press in on the sides of the seat and lower the seat
to insert the tabs on each side of the seat into the
16
vehicle body.
Holes
Battery Retainer
Wing Nut
Vehicle Body