Fisher-Price POWER WHEELS 78475 Owner's Manual & Assembly Instructions page 14

21
Shock Half -
Small
Rear
Support
End
Cap
Rear View
• Fit the large half of one shock set against one of the rear
supports. Make sure the end of the large shock half fits
into the end cap at the bottom of the support.
• Fit the small half of the shock set against the other side
of the rear support. Make sure the end of the small shock
half also fits into the end cap at the bottom of the support.
• Make sure the screw holes in the two shock halves are
aligned.
22
Rear View
• Insert two #6 x / " screws through the holes in the shock
1
2
set halves.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to assemble the other shock set to
the other rear support.
Assembly
23
Shock
Half -
Large
• Position the short half of the rear axle cover behind the
rear axle and snap it onto the rear axle.
• Position the long half of the rear axle cover in front of the
rear axle and snap it into place.
14
Rear Axle Cover -
Short Half
Rear Axle
Rear Axle Cover -
Long Half
Rear View