Listening To The Radio - Sharp SD-AS10W Operation Manual

Listening to the radio

SD-AS10W
ENGLISH
E-37
1
Turn on the power and press the TUNER (BAND) button to set the
input to "FM (AM)".
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band.
FM stereo FM mono
3
Press the TUNING ( or ) button to tune in to the desired station.
Manual tuning:
Press the TUNING button as many times as required to tune in to the desired sta-
tion.
Auto tuning:
When the TUNING button is pressed for 0.5 seconds or more, scanning will start
automatically and the tuner will stop at the first receivable broadcast station.
! When radio interference occurs, auto scan tuning may stop automatically.
Should this happen, tune in manually.
! Auto scan tuning will skip weak signal stations.
! To stop the auto tuning, press the TUNING button again.
You can also use the TUNER (BAND), TUNING DOWN or TUNING UP button on the
main unit.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator.
! " " will appear when an FM broadcast is in stereo.
FM stereo mode indicator
FM stereo receiving indicator
! If the FM reception is weak, press the TUNER (BAND) button to turn off the "ST"
indicator. The reception changes to mono, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
Note for users in Australia and New Zealand:
This product can receive FM stereo/FM monaural and AM monaural broadcasts.
AM stereo broadcasts will not be played in stereo.
05/3/18 SD-AS10W_EX_E.fm
AM
TINSZA124AWZZ