Amana MVH250L Owner's Manual page 45

Installation
STEP 6: ATrACH THE OVEN TO THE WALL
6, Roof-vented installation: Align the damper/duct connector
with the vent on top of the microwave oven. Damper should
be on top of tab. Use two tapping screws (bright-colored) to
attach damper/duct connector to the microwave oven.
See Figure 36.
NOTE: Damper/duct connector must be attached to
microwave oven after microwave oven is installed.
7. Roof venting installation: Install ductwork through the vent
opening in the upper cabinet. Complete the venting system
through the roof according to the method needed. See Figure
37. See PREPARE THE VENTING SYSTEM,
STEP 2. Use caulking gun to seal the exterior roof opening
around the exhaust cap.
See Figure 6.
8. Use the power supply cord clamp to bundle the power supply
cord. Install the power supply cord clamp, using a screw as
shown in Figure 37, to inside of the cabinet.
9. Grasp filter screen with one hand holding the ring and the
other hand holding the opposite end, Insert the end of the
filter screen without ring into the opening and slide towards
the side of the microwave oven. Insert ring end of filter screen
into the opening and slide entire screen towards the center of
the microwave until screen is securely in position. Repeat for
other filter screen.
See Figure 38.
Figure 35
damper ,_
Figure 36
I
i
L ... ...................................... --*.
Figure 36 Detail
duct powerE]
_supplyn
Figure 37
10. Plug in the power supply cord.
11. Read your Owner's Manual, then check the operation of
your microwave oven.
Figure 38
- 45-