The Wireless Control Point, And Installing The Linn Gui And Config Application - Linn AKURATE DS Installation And Setup Manual

AKURATE DS SYSTEM
INSTALLATION AND SETUP
6 THE WIRELESS CONTROL POINT, AND INSTALLING
THE LINN GUI AND CONFIG APPLICATION
You may need to fully charge the battery on the control point before
continuing with this procedure (see the information supplied with the
control device), this may take an hour or longer.
1. Update the control point with .NET 2.0, available at
www.microsoft.com/net.
2. Copy the Linn GUI installer to the wireless control point.*
3. Copy the Linn Config installer onto the installation PC/laptop.**
4. Run both the installers. Do not launch the Linn GUI or Linn Config
at this time.
5. On the control point, disable the 'Auto Right Click' behaviour. This
can be done by locating the notification area at the bottom-right of
the Windows screen, and clicking the Touchkit: USB Controller icon
• Select the Setting tab
• Press the Option button
• Deselect 'Enable Auto Right Click'.
6. The Linn GUI and Linn Config must be given firewall permissions to
allow them to operate. If the PC/laptop uses the Windows Firewall
the Linn software will be added automaticaly, providing you have
admin rights on the PC/laptop. If a different firewall is used, consult
the vendor's manual for instructions on how to add the Linn software
to the list of permissions.
Note:
Each time you update to a new version of the Linn GUI or Linn Config
software, you must add the new software to non-Windows firewalls' list of
permissions.
To configure the Akurate DS system, follow the instructions in The
7.
Linn Config Application section.
* You may wish to add a desktop shortcut to the Linn GUI to make it
easier for the user to find.
** Install the Linn Config on the PC/laptop the customer will use to rip
CDs. This will allow the customer to make changes to their system's
setup (e.g. add a new source), and run the diagnostic tools.
12
www.l i n n.c o .uk