Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Linn KOMPONENT 110
Summary of Contents for Linn KOMPONENT 110
- Page 1 KOMPONENT 110, 106, 104 Advanced Features...
- Page 2 The information in this manual is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by Linn Products Limited. Linn Products Limited assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual.
-
Page 3: Table Of Contents
Levelling (spiked floor-stand mounting only) Connecting General Terminals Cable-routing Configuration options Link strip information Wiring / amping configurations Single-wiring Bi-wiring or bi-amping Tri-wiring or tri-amping Quad-wiring or quad-amping (KOMPONENT 110 & 106 only) AKTIV configuration KOMPONENT 110, 106, 104 ADVANCED FEATURES... -
Page 4: Installation
It can however be converted, by your Positioning Authorised Linn Retailer, to allow the loudspeaker to be positioned vertically. Vertical positioning without conversion is not recommended. The KOMPONENT loudspeakers have been designed to provide a very flexible loudspeaker solution. -
Page 5: Levelling (Spiked Floor-Stand Mounting Only)
(1) and use a screwdriver to turn the spikes to adjust their height (2). Note: To protect wooden or tiled floors, the spikes can be placed on the floor-protectors, which are supplied with the KOMPONENT spiked stands. KOMPONENT 110, 106, 104 ADVANCED FEATURES... -
Page 6: Connecting
Spade-terminated Cable A A K K T T I I V V o o p p e e r r a a t t i i o o n n . . The term ‘AKTIV’ refers to the proprietary Linn active crossovers and loudspeaker configuration, whereby the loudspeaker’s internal... -
Page 7: Link Strip Information
Ensure that all the binding posts are tight (whether the strips are being The configurations below are only suggestions – others are possible. If you are refitted or not). trying other setups, we would advise that you consult an Authorised Linn ● Repeat the process for the second row. -
Page 8: Wiring / Amping Configurations
KOMPONENT 110 or 106 KOMPONENT 104 Bi-wiring or bi-amping Quad-wiring or quad-amping (KOMPONENT 110 & 106) Suggested position of separated link strips if bi-wiring (i.e. using two cables Link strips MUST be removed when quad-wiring (i.e. using four cables from one from one power amplifier channel) or bi-amping (i.e. -
Page 9: (Komponent 110 & 106 Only)
AKTIV configuration Important notes: AKTIV operation requires a modification to your loudspeakers and in some cases, your amplifiers, which must be carried out by an Authorised Linn Retailer. In AKTIV mode, please be very careful to connect all cables from the amplifier(s) to the correct sockets on the loudspeaker.