Using The Plug-On Transmitter; Switching The Plug-On Transmitter On/Off - Sennheiser SKP 100 Instruction Manual

Using the plug-on transmitter

Using the plug-on transmitter
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on (see the instruction manual of the
receiver).
2. Switch the plug-on transmitter on (see below).
The transmission link is established and the diversity receiver's RF level
display "RF" reacts.

Switching the plug-on transmitter on/off

To switch the plug-on transmitter
Press the
ON/OFF
The plug-on transmitter transmits an RF signal. The red
ON LED
Name" appears on the display panel. The transmission icon
is displayed.
You can switch the plug-on transmitter on and deactivate the
RF signal on switch-on. For more information, see below.
To switch the plug-on transmitter off:
If necessary, deactivate the lock mode (see page 9).
Press the
ON/OFF
display panel.
The red
When in the operating menu, pressing the
cancel your entry (ESC function) and return you to the current
standard display.
To switch the plug-on transmitter
switch-on (offline operation):
Press the
SET
display panel.
Press the
SET
The transmission frequency is displayed but the plug-on
transmitter does not transmit an RF signal. The transmission
icon
533.875
ew100 G3
P
AF
Use this function to save battery power or to prepare a plug-on
transmitter for use during live operation without causing inter-
ference to existing transmission links.
To activate the RF
Press the
ON/OFF
"RF Mute
Press the
SET
The transmission icon
8
on
ON/OFF button
lights up and the standard display
ON/OFF button
ON LED goes off and the display panel turns off.
SET button until
SET button.
is not displayed.
MHz
MUTE
signal:
ON/OFF button.
Off" appears on the display panel.
SET button.
(online operation):
.
until "OFF" appears on the
on and to deactivate the RF signal on
"RF Mute On?" appears on the
is displayed again.
"Frequency/
ON/OFF button will