Table of Contents
Advertisement
H
IMPORTANT! Use only a Power Wheels
(4.0 Amp/Hr.) battery with a Power Wheels
installed. Use of any other battery or fuse will damage your
vehicle. Make sure that you charge the battery for at least
18 hours using the enclosed Power Wheels
before operating your vehicle for the first time. Charge the
battery for at least 14 hours after each use of the vehicle.
Never charge the battery longer than 30 hours. Failure to
follow these instructions may damage your battery and will
void your warranty.
1
Seat
• To unlock the lock fastener, use a slotted screwdriver
to rotate the lock fastener
position
.
• Push firmly on one of the back fenders while pulling up on
the same side of the back of the seat to release the tab on
the seat from the slot in the vehicle body.
• Repeat this procedure on the other side of the seat.
• Lift the seat to remove it from the vehicle body.
2
• Using a Phillips screwdriver, loosen the screws in the
battery clamp. Remove the battery clamp from the
vehicle body.
• Place the Power Wheels
upright in the battery compartment. Make sure the bat-
tery connector extends toward the rear of the vehicle.
• Make sure a Power Wheels
condition, is installed in the battery.
Battery Installation
®
6 Volt
®
25 amp fuse
®
6 Volt charger
Push and
Lock
Lift Here
Fastener
Push and
Lift Here
1
/
turn to the unlocked
4
Battery
Battery
Connector
®
6 Volt (4.0 Amp/Hr.) battery
®
25 amp fuse, in good
3
• Position the battery clamp over the battery with the ends
of the battery clamp aligned with the screw holes in the
vehicle body.
• Insert two #10 x
battery clamp and into the vehicle body.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
4
Battery
Connector
• Plug the battery connector into the motor harness connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again! Do not force
the battery connector into the motor harness connector.
• Re-assemble the seat to the vehicle body. (See assembly
step 20 on page 12.)
IMPORTANT! Always remember to keep the lock fastener
locked at all times to prevent children from accessing
14
the battery.
Battery
Clamp
7
/
" screws through the ends of the
8
Battery
Motor
Harness
Connector
Advertisement
Table of Contents
