Table of Contents
Advertisement
18
Footrest
• Fit the footrest to the peg on the underside of the
vehicle body .
19
• Insert three #8 x
3
/
" screws through the battery
4
compartment in the vehicle body and into the footrest.
Assembly
Vehicle Body
Peg
Footrest
20
Lock Fastener
LOCKED
Note: If you have already charged your Power Wheels
6 Volt (4.0 Amp/Hr.) battery for at least 18 hours, you may
want to install it in the battery compartment before assem-
bling the seat to your vehicle. Please refer to the Battery
Installation section beginning on page 14 for instructions.
• Insert the tabs on the front of the seat into the slots in the
vehicle body.
• Press down on the back of the seat to snap the tabs on
the back of the seat into the slots in the vehicle body.
• Using a slotted screwdriver turn the lock fastener a
quarter turn to lock seat into place.
• Once the seat is assembled to the vehicle body, use a
slotted screwdriver to rotate the lock fastener
the locked position
• To unlock the lock fastener, use a slotted screwdriver
to rotate the lock fastener
position
.
IMPORTANT! Remember to keep the lock fastener
locked at all times to prevent children from accessing
the vehicle battery.
12
Lock
Seat
Fastener
Lock Fastener
UNLOCKED
1
/
turn to
4
.
1
/
turn to the unlocked
4
®
Advertisement
Table of Contents
