S Ave'command; E Xit'command; R Eboot'command - Sena HelloDevice LS100 User Manual

2.4.5 'save' Command
With 'save' command, current parameter changes are saved to non-volatile memory. Command usage
of 'save' command is as follows:
save + <CR>
Saved changes will be applied if the LS100 is rebooted by 'reboot' command or manual rebooting.
2.4.6 'exit' Command
With 'exit' command, current serial or remote console session will be closed. However, changed
parameters are not applied until the LS100 is manually rebooted. Command usage of 'exit' command
is as follows:
exit + <CR>
2.4.7 'reboot' Command
With 'reboot' command, the LS100 will be rebooted immediately. Changed parameter values will be
applied when the LS100 is up again. Command usage of 'reboot' is as follows:
reboot + <CR>
22