G Et'command - Sena HelloDevice LS100 User Manual

if ipmode = dhcp,
no parameters required
if ipmode = pppoe,
par1 = PPPoE username,
par2 = PPPoE password
>
Note:
The changed values will not take effect until 'save' and 'reboot' commands are invoked. For more
details, please refer to section 2.4.5 ~ 2.4.7.
2.4.2 'get' Command
With 'get' command, users can view the current parameter values and status of the LS100. Basic 'get'
command usage is as follows:
get [group] + <CR>
where,
group = 'ip','host','serial' , 'admin' or 'status'
- If group is specified, shows settings of the group.
- If group is omitted, shows settings of all groups.
The group means the category where parameters belong to as like 'set' command. For example, if
users want to view parameter values related to IP configuration, get command as Figure 2-12
can be used.
> get ip
IP_mode: static
IP_address: 192.168.1.100
Subnet_mask: 255.255.255.0
Gateway: 192.168.1.1
>
'status' group is a special group where 'set' command does not apply. 'get status' will show current
system status screen.
> get status
Serial_no.: LS100-0207_test
MAC_address: 00-01-95-77-88-99
F/W_REV.: V1.2.0
Current_IP: 192.168.0.125
>
Figure 2-11 Help screen example
Figure 2-12 Getting ip configuration screen
Figure 2-13 Getting status screen
19