Command Usage - Sena HelloDevice LS100 User Manual

of serial console will be displayed. The user can set, get, save configuration parameters and
exit console, reboot the device as like the serial console.
4) If serial console or the other remote consoles are connected already, new console will not be
established at all.

2.4 Command Usage

The LS100 provides several simple commands for configuration and control of the LS100. Table 2-2
summarizes command set which LS100 supports.
Command
set group par1 [par2 ...] + <CR>
get [group] + <CR>
help [group] + <CR>
factorydefault [option] + <CR>
save + <CR>
exit + <CR>
reboot + <CR>
Table 2-2 LS100 command set summary
Description
Set configuration parameters
- group = 'ip', 'host', 'serial' or 'admin'
- par1 ... = configuration parameters. Use * to
keep a parameter's value
Get configuration parameter values
- group = 'ip', 'host', 'serial', 'admin' or 'status'
- If group is specified, shows settings of the
group.
- If group is omitted, shows settings of all groups.
Shows command usage screen.
- If group is omitted, shows help screen.
- If group is specified, shows 'set' command
usage of the group.
Restore factory default values
- if option is omitted, all parameters are set with
factory default values.
- if option='-ip', all parameters except IP settings
are set with factory default values.
Save changes
Exit without rebooting the device (changes are
not applied)
Exit and reboot the device
17
Result
If success,
"OK" + <CR> + <LF>
If error
"ERROR" + <CR> + <LF>
Parameter value display
Help message display
If success,
"OK" + <CR> + <LF>
If error
"ERROR" + <CR> + <LF>
If success,
"OK" + <CR> + <LF>
If error
"ERROR" + <CR> + <LF>
If success,
"OK" + <CR> + <LF>
If error
"ERROR" + <CR> + <LF>
None