Command Usage - Sena HelloDevice Lite Series User Manual

Type the following command in the command line interface of your computer.
Or run a telnet program with parameters as follows.
2) The user has to log into the LS100W. Type the user name and password. A factory default
setting of the user name and password are both admin.
3) If the user logs into the LS100W successfully, the same command prompt screen as the
serial console will be displayed. The user can set, get, save configuration parameters and
exit console, reboot the device as like the serial console.
4) If serial console or the other remote consoles are connected already, new console will not be
established at all.

2.4 Command Usage

The LS100W provides several simple commands for configuration and control of the LS100W. Table
2-2 summarizes command set which LS100W supports.
Command
set group par1 [par2 ...] + <CR>
get [group] + <CR>
help [group] + <CR>
telnet 192.168.1.254
Figure 2-7 Telnet program set up example
Table 2-2 LS100W command set summary
Description
Set configuration parameters
- group = 'ip', 'host', 'serial' or 'admin'
- par1 ... = configuration parameters. Use * to
keep a parameter's value
Get configuration parameter values
- group = 'ip', 'host', 'serial', 'admin' or 'status'
- If group is specified, shows settings of the
group.
- If group is omitted, shows settings of all groups.
Shows command usage screen.
16
Result
If success,
"OK"+ <CR> + <LF>
If error
"ERROR" + <CR> + <LF>
Parameter value display
Help message display