F Actorydefault'command - Sena HelloDevice LS100 User Manual

- If group is omitted, shows this screen.
- If group is specified, shows 'set' command usage of the group.
factorydefault [option] + <CR>
- if option is omitted, all parameters are set with factory default values.
- if option='-ip',
all parameters except IP settings are set with factory default values.
save + <CR>
- Save changes
exit + <CR>
- Exit without rebooting the device
reboot + <CR>
- Exit and reboot the device
> help ip
set ip ipmode par1 par2 ...
- ipmode: static=Static IP / dhcp=DHCP / pppoe=PPPoE
- parameters:
if ipmode = static,
par1 = IP address,
par2 = subnet mask,
par3 = gateway
if ipmode = dhcp,
no parameters required
if ipmode = pppoe,
par1 = PPPoE username,
par2 = PPPoE password
2.4.4 'factorydefault' Command
With 'factorydefault' command, users can load factory default parameter values in console. Command
usage of 'factorydefault' is as follows:
factorydefault [option] + <CR>
where,
- if option is omitted, all parameters are set with factory default values.
- if option='-ip', all parameters except IP settings are set with factory default values.
Loaded values are not saved until 'save' command invoked. After 'factorydefault" command, 'save' and
'reboot' commands are required for changes to take effect.
> factorydefault (or factorydefault –ip)
OK
> save
OK
> reboot
Figure 2-15 Help screen
Figure 2-16 Help screen with 'ip' group specified
Figure 2-17 Factory default reset screen
21