Also Available From Seco-Larm - SECO-LARM E-941SA-600 Manual

SECO-LARM
ELECTROMAGNETIC LOCK
10
. Once the position of the mounting plate is correct,
use the four long self-tapping screws to permanently
mount the mounting plate.
Long self-tapping screws
12.
Remove the cover from the front of the
electromagnet. Run the power leads through the
large cable access hole .
Skip this step for E-941SA-300. Power leads are
pre-installed. Faceplate does not detach.
14.
Cut the wires so they are long enough to connect
with the terminal block. Set the voltage using the
selection jumpers based on your input voltage.
Voltage Selection Jumpers
Position two jumpers
on all four pins for
12VDC operation
NOTE: Failure to correctly set the input voltage may cause
damage to the lock.
NOTE: Connect switching devices like push-to-exit
switches between the power source and the positive
terminal on the lock. Connecting switching devices to the
negative terminal may cause a delay in unlocking.

Also Available from SECO-LARM:

Access Control
Power Supply
EAP-5D1Q
6
Position a jumper over
the two middle pins for
24VDC operation
Stand-Alone
Access Keypads
SK-1123-SQ
(shown)
11.
Drill the cable access hole. Run the power leads
through the cable access hole in the mounting plate
and through the hole in the door frame.
13
. Push the electromagnet against the mounting plate
so the electromagnet ends are flush with the ends of
the mounting plate. Use the Allen wrench to screw
the hex-head mounting screws through the bottom
of the electromagnet into the mounting bracket.
15.
Connect the power wires according to the wiring
diagram on page 7. Test the unit. Then replace the
front cover and install the hex-head tamper caps.
NOTE: This should be the very last step, as once the
tamper caps are in place they are very difficult to remove.
Complete line of
Electromagnetic
Locks and Strikes
E-941DA-1K2P
(shown)
Voltage
Wired or Wireless
Converters or
Booster
ST-LA110-TTQ
SD-7202GC-PEQ
(shown)
SECO-LARM U.S.A., Inc.
RTE Plates
(shown)