Jumper Settings; Jumper Selection - Scytek electronic VISIONGUARD 6000 Product Manual

Jumper Selection

Carefully separate the top and bottom halves of the main unit case. Once the cover is removed, the parking
light polarity jumper will be visible next to the parking light relay. Set the jumper for the correct polarity
output as described below, then reassembly the main unit case.
Parking Light Output. Selects the polarity (+/-) for the output of the on-board Parking Light relay.
Left Pin + Center Pin = positive
Right Pin + Center Pin = negative

Jumper Settings

default setting shown
VisionGuard 6000 - Page 19