Remove The Grille To Install The Indoor Unit - Sanyo KS1852 Installation Instructions Manual

3-4. Remove the Grille to Install the Indoor Unit

Basically, these models can be installed and wired with-
out removing the grille. If access to any internal part is
needed, follow the steps as given below:
How to remove the grille
(1) Set the flap in the horizontal position.
(2) Unscrew the screws. (Fig. 16a or 16b)
(3) Remove the grille. (Fig. 17)
(a) Hold both corners of the air intake grille, then
pull out and up to open.
(b) Pull the lower part of the grille toward you to
remove.
(c) Use a standard screwdriver to push up the 3
tabs to remove the grille.
How to replace the grille
(1) Close the flaps.
(2) Reinstall the grille into the lower part while aligning
its tabs on the upper part. (Fig. 18) Insert the tabs in
the slots and push the lower part of the grille back
into position.
(3) Press at each of the 4 tabs to completely close the
grille. Make sure that the grille and frame are firmly
fitted together. (Fig. 19)
KS0951, KS1251
Flap
(Up and down air direction louvre)
KS1852
8
Screw cover
Fig. 16a
Fig. 16b
Air intake grille
Fig. 17
Fig. 18
Fig. 19